Default Voltage of LGA775 Cpu´s

[Rom Hacker]

Hi,
This is my 1st Post/Topic on Team OCX Forum :)
I am From Portugal and i have 14 years.
I want to know the Default Voltage of :
Celeron D 331
Celeron D 330
To do that mod:
VrZone Pin Mod-Voltage Boost (http://sg.vr-zone.com/articles/Pin_Mod_LGA_CPUs_for_Voltage_Boost/3931-7.html)
And i don´t know the Default Voltage(VID) of that Cpu´s(D330/D331)...
Can i do the mod with a Pencil?:D

Greetings
And Sorry for my bad English :ocx2008s15:

[Sam]

first of all, welcome to OCX :ocx44:

you can check the default voltage for your CPU (the VID, as it's also called) via CoreTemp or by CPUz (change sensor=ON to sensor=OFF in the config file of the CPUz and instead of Vcore it will be showing VID) :)

[Rom Hacker]

first of all, welcome to OCX :ocx44:

you can check the default voltage for your CPU (the VID, as it's also called) via CoreTemp or by CPUz (change sensor=ON to sensor=OFF in the config file of the CPUz and instead of Vcore it will be showing VID) :)
Thanks Dude :D,
My Cpu-Z only show mee a Big VDroop(That´s normal,my board it´s Low low End).
It´s a ECS P4M800PRO-M V1.0 :(
1.285~1.360V :/
Btw,
In this situation i will do 1.3125V Defaulters Pin Mod?
Greetings and Thanks TaPaKaH :)

[Sam]

your welcome :)

yeap, ~0.1Vdrop may be a problem on cheap boards

the default voltage of CPU is VID : if software I suggested shows 1.3125V - then do as if it's 1.3125V stock voltage CPU

[Rom Hacker]

Thanks one more Time TaPaKaH
Can i do the mod with a Pencil?
Greetings :D

[Sam]

don't think that LGA775 pinmods are doable with pencil

[Rom Hacker]

don't think that LGA775 pinmods are doable with pencil

:ocx2008s05:
Ok,
So i must buy Conductive Ink?
Greetings

[pal]

for me work on E6600, but I was doing strap from original 1066 to 1333 with conducitve pen. But no work long. Few restarts and was like before,1066mhz.